The BB-12014 sheet metal brake has a 120" wide web width to allow for 4' x 8' sheets to be bent at 45 degree angles. This finger brake has 26 varying sized fingers that allows for metal bending of most size box and pans up to 6" deep. This massively built machine almost weighs in at 3500 lbs and supports a heavy duty truss rod system for supporting the apron during maximum capacity bends.

Free Shipping to COMMERCIAL ADDRESSES* within the lower 48 United States!

Baileigh Industrial Roll Bender R-M20-110

Rolling coils is one of the hardest thing to do in metal forming. This is where the R-M20 comes in and makes easy work of the job. The R-M20 from Baileigh Industrial is the perfect Ring and Angle Roll Bender for doing small diameter material or coils because of its tight compact roll formation. Lateral guides are also adjustable, making it easy to bend just about any width coil imaginable. Rolling operation on the R-M20 is done via a set of foot pedals for forward and reverse roll direction. An emergency stop is also integrated for safety. An easy to read digital display, shows the top roll position to make repeatability a snap.

Baileigh Industrial R-H120E Double Pinch Roll Bender

Our R-H120E hydraulic tubing roller costs less than our R-H120 ring roller but offers many of the same time-saving features.

• Runs on 220-volt 3-phase power.
• 3 driven rolls, made of hardened segmented steel, can tackle a capacity of up to 5.5 round tube and 4.5 schedule 40 pipe.
• 2 independent hydraulic cylinders connected to bottom rolls accomplish pre- and post-bending for tighter rolling.
• You can manually adjust the lateral angle guides to ensure correct bend angle and prevent material from twisting.
• Movable operator control podium includes digital readout for the roll positions with a programmable stop.